White Grease

Rymax White Grease is designed to reduce friction between load bearing moving metal surfaces and/or the combination of metal and plastic surfaces. Rymax White Grease also protects metal surfaces from corrosion and has very good nonconductive properties. How to use?Before use, carefully read the directions on the packaging and act accordingly. The aerosol should have room temperature. Best processing temperature 5 to 30°C. Before use, shake the aerosol. Apply the White Grease in a thin layer. Optimum lubrication is obtained after evaporation of the solvent.

Vector R

Rymax Vector R is recommended for ABS and ASR racing brake systems. Especially the low viscosity, compared to the original DOT 4 brake fluids, stands out. Rymax Vector R is particularly suitable for and also prescribed in new brake systems. These racing systems are mostly characterized by thinner brake fluid pipes (more flexible, less material). At low temperatures, these systems require a brake fluid with a lower viscosity to guarantee a rapid response time. Rymax Vector R has a high ‘wet boiling point’ by which the risk of vapour lock is strongly reduced. Vector R can be mixed with other synthetic brake fluids meeting FMVSS 116 DOT 3, DOT 4 and DOT 5.1 specifications and can be applied in systems prescribing these specifications.

Vector 4+

Rymax Vector 4+ is recommended for ABS and ASR brake systems. Especially the low viscosity, compared to the original DOT 4 brake fluids, stands out very well in these systems.Rymax Brake Fluid DOT 4+ is particularly suitable for and also prescribed in new brake systems (a.o. Opel Vectra C, VW Passat B6 and other modern cars build after 2004). These new systems are mostly characterized by thinner brake fluid pipes (more flexible, less material). At low temperatures, these systems require a brake fluid with a lower viscosity to guarantee a rapid response time. Rymax Vector 4+ has a high ‘wet boiling point’ by which the risk of vapour lock is strongly reduced. This is important when asbestos-free brake lining is used or for frequent braking (e.g. in mountain areas and/or driving with a trailer) and the connected higher heat generation. Vector 4+ can be mixed with other synthetic brake fluids meeting FMVSS 116 DOT 3, DOT 4 and DOT 5.1 specifications and can be applied in systems prescribing these specifications. This brake fluid will not affect cup seals, brake fluid pipes or seal rings.

Vector 4

Our Brake Fluid DOT 4 is a high performance brake and clutch fluid with a minimum boiling point of 260°C , exceeding SAE J1704 and meeting or exceeding United States Federal Motor Vehicle Safety Standard No. 116 DOT 4 specifications. Our Brake Fluid DOT 4 provides excellent corrosion protection and rubber seal compatibility. Rymax Brake Fluids are completely miscible with one another and are compatible with other approved DOT glycol ether and borate brake fluids. However, do not mix with silicone type or silicate ester type brake fluids. Good brake fluid quality is essential for the system to operate under severe conditions. In service, the brake fluid absorbs moisture which causes a significant reduction in the boiling point of the brake fluid. A consequent risk of this is so-called “vapour lock”. Vector DOT 4 exceeds the international standards specifying minimum values for the wet and dry boiling point. In doing so, we offer a substantial safety margin against water pick up.

Styx UTTO

Styx UTTO is an outstanding multifunctional hydraulic and transmission oil for tractors. Styx UTTO is suitable for tractors that need one lubricant for the hydraulic system, the transmission, differential, wet brakes and clutches. Styx UTTO is formulated from mineral base oils with special additives to improve viscometrics, it contains anti friction and extreme pressure to prevent wear and tear of metal surfaces at high revs and heavy loads. Styx UTTO is suitable for all modern tractors. Styx UTTO is not an engine oil.

Silicone Spray

The Rymax Silicone Spray is a multiuse product and can for example be used to lubricate and protect rubber and plastic components such as door seals, locks, bumpers, belts and much more. The powerful formula of the spray ensures excellent lubrication while not leaving any stains. Its water repellent properties ensure protection against moist.

Rymax Additives TDS Oil Leak Preventer

Rymax Oil Stop Leak is a specialty product meant for use when common problems like oil leaks or exhaust smoke occurs. It is specially designed to help rejuvenate seals and gaskets and improve sealing at valve guides, piston rings and cylinder walls. This results in a reduction or stop of oil loss and oil contamination and in better compression and thus superior engine performance. How to use?The additive can be used in all gasoline, diesel and LPG engines, with or without turbochargers. Mix this additive with the Rymax engine oils for an optimal result. DosageAdd the contents of one bottle Oil Leak Preventer to the warm motor oil, preferably shortly after oil change. The Rymax bottle of 250 ml Oil Leak Preventer treats 3 to 6 litres of motor oil. Note: make sure the oil contents do not exceed the maximum oil level in your engine.

Rymax Additives TDS Octane Booster

The Rymax Octane Booster is developed to boost octane level by 2 – 4 points, improve and restore performance and clean fuel intake systems. How to use?All gasoline (leaded or unleaded) engines with injectors or carburetor. Will not harm catalytic converters. Pour the contents of one bottle in the fuel tank before filling it with gasoline.

Rymax Additives TDS Engine Flush

Rymax Engine Flush is a specialty product consisting of highly effective cleaning detergents which is to be used prior to regular oil changes. It removes gums, varnish, sludge and contaminants like carbon deposits and cleans the oil system for optimum performance. How to use?For all gasoline, diesel and LPG engines with or without turbo chargers. Compatible with all mineral, semi synthetic or fully synthetic motor oils. DosageOne bottle treats a crankcase of 3 to 6 litres.

Radiator Leak Protector

The Rymax Radiator Leak Protector permanently and reliably seals and prevents within seconds hair cracks and small leakages in the radiator, the heater radiator, the water pump, the cylinder head gasket and the engine block. It lubricates the pump and protects the entire cooling system against rust and corrosion. The additive can be used in all the aluminium, plastic and steel radiators of cooling systems in gasoline, diesel and LPG engines. This protector is compatible with water, cooling fluids and conventional anti freeze.How to use?It is important to shake the can before use. Add the contents of the can to the cooling system with switched-on heating and warm (not hot) running engine. Keep engine running for approximately 10 minutes or drive a short distance. Note: Be careful when opening the radiator / cooling system: hot coolant or steam might escape from the system. Dirty cooling systems should first be cleaned. DosageOne bottle is sufficient for cooling systems with a volume of up to 12 litres.

PTFE Spray

Rymax PTFE Spray is an invisible, multi-purpose non toxic PTFE spray for use as an anti-stick agent for chutes and slides. It is particularly suitable for applications operating in food, pharmaceutical or other clean industries where ‘wet’ lubricants cannot be tolerated. It provides a light, long life, totally dry lubricant film for all kinds of applications.

Posidon

Posidon comes in two semi synthetic blends; SAE 10W/30 and SAE 10W/40, and in three full synthetic blends; SAE 5W/30, SAE 5W/40 and SAE 5W/50. These synthetic technology engine oils meet the modern requirements of the passenger car manufacturers. Posidon has been designed to deliver long service life and minimizes deposits in engine turbocharger to ensure rated engine power and torque.

Notus A-40

Rymax Notus A-40 is a high quality effective spray and can be used as lubricant, rust remover, contact spray, anti corrosion and tool cleaner. Rymax Notus A-40 is used for; fastening tools, screwed connections rails, gear wheels chains, locking garden tools and for fastenering (screw, bolt and nuts) reels.

Motrax 4T FS

Motrax 4T

Motrax 4T FS is a full synthetic engine oil without friction modifiers, especially developed for 4-stroke motorcycles. This oil can also be applied in motorcycle transmissions where a SF, SG, SH or SL oil is prescribed/advised. Motrax 4T FS is suitable for touring, racing and cross applications and contains additives that ensure excellent anti-wear, extreme pressure and anti-corrosion properties as well as a high viscosity index. Effective detergent and dispersant additives enable the oil to minimize deposits and contaminants. Motrax 4T FS provides perfect protection to the gears and wet clutches. This product is Red in colour.

Motrax 2T

Motorcycle Engine oil 2T Mineral is a high quality mineral lubricants suitable for use in air-cooled 2-stroke engines, in diverse applications. Three grades, called TSC-1, 2 or 3 are available. Depending on the grade, it can used in different applications

Lindax EP 2

Lindax EP NLGI 2 is a lithium thickened lubricating grease based on virgin mineral oil. The product is a general multipurpose grease which can be used in various applications within given temperature limits. It contains Extreme Pressure additives and can be used in a wide range of industrial and automotive applications. Rymax Lindax EP NLGI 2 grease is suitable for a large range of plain- and rolling bearings.

Leto MV

Leto is a Multi-Vehicle, full synthetic hydraulic oil for levelling system, highly stressed centralized hydraulic system, shock absorber and power steering system. It is based on advanced technology with excellent viscosity performance at different temperatures and optimized shear stability.

Hygea

Rymax Hygea is an universal degreaser, used for cleaning and degreasing machine- and motor spare parts, engine rooms, tanks, floors and any other dirty parts. This product is suitable for use in general industries such as workshops, factories, shipping industry, agriculture, aviation, petrochemical industry, process industry and printing industry. Thanks to its neutral pH-value, it can be used on all surfaces and can be flushed with water. It is formulated with powerful acting emulsifiers and slow evaporating solvents. It should be used undiluted.

Hydra AW 22/32/46/68/100

Rymax Hydra AW (anti-wear) oils are high performance anti-wear hydraulic oils developed for high pressure hydraulic systems, operating under moderate to severe conditions in mobile- and industrial services. Rymax Hydra AW oils are formulated with high quality base oils and carefully selected performance additives to provide excellent protection against oxidation degradation, rust and corrosion and wear. Rymax Hydra AW oils also possess superior foam control, water separation and rapid air release properties. Rymax Hydra AW oils are formulated with field proven thermally stable zinc based anti-wear additives. Rymax Hydra AW can be used in hydraulic systems operating under moderate and severe conditions in mobile- and industrial circumstances and in older hydraulic systems where leakage is a problem and a cost-effective hydraulic oil providing all-round protection is required. You can think of mobile hydraulic fluid power transmission systems and general machine lubrication.